Bane Covertech Swap

In order to add a covertech knob to your curved saber follow the guide below.

First Steps

Check to make sure you were provided with the above items. If any item is missing, contact customer service.

Remove Side Screw

1

Locate the screw on the side of your curved saber and use the provided hex key to remove by rotating counter-clockwise

Prepare covertech knob

2

Prepare the covertech knob by placing the screw inside your covertech knob

Install covertech knob

3

Screw in and tighten down (rotating clockwise) the new Covertech Knob using the provided hex Key.

Complete

Your covertech knob should be installed and secured on your Bane saber