Saber Stand Setup
Instructions for building your saber stand. Your stand may look different but these steps will work for all saber stands.
Getting started
Check to make sure you were provided with items pictured below. If any item is missing, contact customer service.
Installation steps
- 1
-
Each stand side will come with a protective paper covering. Remove them from each side of the stand wall. Each stand side will come with a protective paper covering. Remove them from each side of the stand wall.
-
Use one of the provided screws and place it through the back hole of the saber stand. Then take one the stand supports and screw them together.
- 3
-
Use a second screw to secure the support to the second stand wall. You can tighten both screws using the provided hex key.
-
- 4
-
Using the same steps as the first support, repeat the process.
-
- 5
-
Make sure to tighten both sides using the hex key.
-
Completed Stand
